-
Dec 10, 2023What Are The Characteristics Of Thin-walled Injection MoldsThe exhaust performance requirements of the mold. Due to the shorter filling time and faster injection speed of thin-walled injection molding compared to ordinary injection molding -
Dec 09, 2023Preventive Methods For Deformation Of Tableware Molds During Heat TreatmentOn the premise of ensuring the hardness of tableware molds, try to use pre cooling, graded cooling quenching, or warm quenching processes as much as possible. -
Dec 08, 2023Theoretical Basis For Forming Thin-walled MoldsIf thin-walled molds need to be produced well, then the fluidity of thin-walled injection molding materials must be good -
Dec 07, 2023What Are The Uses Of Thin-walled MoldsThe thin-walled bearing ring stretching and stamping die is mainly used for producing thin-walled bearing rings. -
Dec 06, 2023Maintenance Of Thin-walled MoldsThe maintenance of thin-walled molds is more important than the maintenance of thin-walled molds. -
Dec 05, 2023Design Of Cooling System For Thin-walled MoldsThe design of a cooling system is a complex task, which involves considering the cooling effect and uniformity, as well as the impact of the cooling system on the overall struct... -
Dec 04, 2023Construction Of Thin-walled MoldsThe mold adopts an I-shaped structure, with P20 or 2738 for the cavity and core, 2316 or 718 for the slider, guide groove, and insert. -
Dec 03, 2023Design Of Thin-walled MoldsWhen designing a mold, the front mold should first pop out 0.05-0.1mm to facilitate air blowing and prevent the product from sticking to the front mold -
Dec 02, 2023Materials For Thin-walled MoldsThe front and rear molds are made of heat-treated steel materials such as 2344, S136, DC53, GS767, etc., and treated to HRC48-52 to extend the mold life and prevent rust -
Dec 01, 2023Technical Difficulties in Thin-walled MoldsWhen designing, it is necessary to avoid large-scale machining to avoid affecting the machining performance of the workpiece.
